General

How To Prime Davey Torrium 2 Pump

How to Prime a Davey Torrium 2 Pump

You are not the only one who is unsure how to prime a Davey Torrium 2. It’s important that you follow the manufacturer’s instructions carefully. It is important to ensure that the pump is not being disassembled until the pressure has been released. A properly primed Torrium 2 pump will operate more efficiently and effectively. If you’re unsure about how to prime a Davey Torrium 2 pump, read on.

The first step in priming a Davey Torrium pump is to make sure that the motor is powered by the proper voltage. If the pump is powered by a DC motor, make sure that it is plugged into the right power supply. The voltage should be at least 18V. If not, you must increase the voltage to avoid any damage to the motor. To make sure the motor isn’t tripping, you can also check its thermal overload.

The Torrium 2 pump comes with a reset button. This is useful for initial priming or if the pump has been switched to pump protection mode. Before you begin priming your Torrium 2, make sure that the water supply line is full and the gate valve is open. The pressure control switch is also important to check. It can be damaged or not set correctly, which will negatively impact the pump’s performance.

You may need to repeat the process multiple times depending on which type of water tank you have. If you have a steel bladderless pump you should always leave the drain open. This is the best way for water to flow into the tank. This pressure is essential for your pump’s proper operation. You may need to repeat the process if the pressure in your water tank is too high.

Leave a Reply

Your email address will not be published. Required fields are marked *